Car’s Engine Stalling. If the crank position sensor is going bad but still functional at times, the vehicle’s engine may start normally but then rough idle on other occasions. It could also be hard starting the car, or you may feel more intense engine vibrations when you start the car. In some cases, you could have an engine misfire.
TIP 1: The crankshaft position sensor is located on the timing chain cover. More specifically, it's located to the right (passenger side) of the crank pulley and behind the A/C compressor. TIP 2: It's very important that the battery on your Ford car (pick up or SUV) must be fully charged for this test. The battery must have enough reserve power A P0335 "check engine light" code could be caused by: Damaged CKP sensor connector. Damaged reluctor ring (missing teeth or not turning due to sheared-off keyway) Sensor output open. Sensor output shorted to ground. Sensor output shorted to voltage. Failed crank sensor. Broken timing belt.

4.0L. The Crankshaft Position Sensor (CKP) is mounted to the transmission bellhousing at the left/rear side of the engine block. Engine speed and crankshaft position are provided through the crankshaft position sensor. The sensor generates pulses that are the input sent to the powertrain control module (PCM). The PCM interprets the sensor input

Duralast Crankshaft Position Sensor SU14114. Part # SU14114. SKU # 257650. Limited-Lifetime Warranty. Check if this fits your 2015 Ford Focus. Notes: Sensor only. PRICE: 63.99. Connector Shape: Female Connector / 3 Male Blade. Connector Gender: Female Connector / 3 Male Blade.
Sun 19 Jan 2020 06:51. Ford Focus - Crankshaft sensor - Michael Magor. I've had the code read and I've been told it's either that or the camshaft sensor. He's recommended to change both as it's shows the same fault. I was going to start with the camshaft sensor as its easier. It was the reposition to TDC that I was concerned about. . 781 938 474 913 973 384 869 336

ford focus crankshaft sensor location